30
System
2nd 3rd Description
DisplayPort Ver.
Select the DisplayPort version to use.
―
Incorrect settings may cause the screen to go blank. If this occurs, check the device specifications.
Input Port Ver.
Select an HDMI version.
―
The supportable device and resolution may differ depending on its version.
―
When the version is changed, the screen may blink.
―
If you set the HDMI Mode to 1.4, some high resolutions may not be supported because of bandwidth limitation of the HDMI 1.4 protocol.
―
When the setting is not appropriate, a blank screen may appear. In this case, check the specifications of the device.
Volume
Change the Volume setting.
Eco Saving Plus
Reduce energy consumption compared to consumption at the maximum brightness level.
• Off: Deactivate the Eco Saving Plus function.
• Auto: The power consumption will automatically be reduced by about 10% over the current setting.
(The reduction of power consumption depends on the customer screen brightness condition.)
• Low: Saves up to 25 % energy compared to the maximum brightness.
• High: Saves up to 50 % energy compared to the maximum brightness.
―
This option is not available when Picture Mode is in Dynamic Contrast mode.
―
This menu is not available when Game Mode is enabled.
―
This menu is not available when Eye Saver Mode is enabled.
―
This menu is not available when PIP/PBP Mode is enabled.
To Next Page
Loading...
