Health information
Exposure to Radio Frequency (RF) Signals
Certification Information (SAR)
Your device is
a
radio transmitter and receiver. It is designed and
manufactured not to exceed the exposure limits for radio frequency
(
RF) energy set
by the Federal Communications Commissio
n(
FCC
)
of the U.S. government. These
FCC exposure limits are derived from the recommendations of two expert
organizations, the National Counsel on Radiation Protection and Measurement
(
NCRP) and the Institute of Electrical and Electronics Engineers
(
IEEE). In both
cases, the recommendations were developed by scientific and engineering experts
drawn from industry, government, and academia after extensive reviews of the
scientific literature related to the biological effects of RF energy.
The exposure limit set by the FCC for wireless mobile phones employs
a
unit of
measurement known as the Specific Absorption Rate
(
SAR). The SAR is
a
measure
of the rate of absorption of RF energy by the human body expressed in units of watts
per kilogram
(
W/kg). The FCC requires wireless devices to comply with
a
safety limit
of
1.6
watts per kilogram
(1.6
W/
k
g). The FCC exposure limit incorporates
a
substantial margin of safety to give additional protection to the public and to account
for any variations in measurements.
SAR tests are conducted using standard operating positions accepted by the FCC
with the device transmitting at its highest certified power level in all tested frequency
bands. Although the SAR is determined at the highest certified power level, the
actual SAR level of the device while operating can be well below the m aximum value.
This is because the device is designed to operate at multiple power levels so as to
use only the power required to reach the network. In general, the closer you are to
a
wireless base station antenna, the lower the power output.
Before
a
new device is available for sale to the public, it must be tested and
certified to the FCC that it does not exceed the exposure limit established by the
FCC. Tests for each device are performed in positions and locations as required by
the FCC.
For hand held operation, this device has been tested and meets the FCC RF
exposure guidelines.
SAR information on this device can be viewed on-line at
http://www.fcc.gov/oet/ea/fcc id/
.
Please use the FCC ID number A3LEKGC100A
for search,and the ID number can be found on the label that is located on the bottom
side of the device.
Once you have the FCC ID number for
a
particular device, follow the
instructions on the website and it should provide values for typical or maximum SAR
for
a
particular device.
To Next Page
Loading...
