156
Customizing Your Remote
1. From the top of the main screen, tap
(Remote
Control)
➔
Set Up Now
.
2. From the
Select your TV Brand
screen, tap your TV’s
manufacturer name.
•
If you have a brand of TV not listed or you are using a projector,
select from one of the following two options. Choose from
either
Show other brands
or
I have a home projector
.
3. Aim your device at the TV and tap (
Power
) to
confirm the set up process completed successfully and
the correct TV IR codes were selected.
Note:
The process of the initial TV activation can take up to 10
seconds. Please do not press the button again.
4. If the TV turned on, tap
Yes
.
– or –
If the TV did not turn on after tapping (
Power
) and
waiting 10 seconds, tap
No
or
Retry
.
5. From the
Select your channel source
screen, select the
entry that corresponds to your current channel control
method:
•Set-top Box
: selected when changing channels is done via a
receiver box. Channels are not changed via the TV remote but
rather through the receiver/box.
• My xxx TV
: selected when a signal is fed directly into the TV
and no box is used. Channels are changed directly on the TV by
using the TV remote and not a box’s remote.
Note:
Try matching your current channel selection method.
6. Select the Satellite Box Brand from the available list.
•
If your brand does not appear in the list, tap
Other Satellite
Box Brands
and follow the on-screen instructions.
Important!
You must configure your set top box for IR
communication with your device. If you do not
select
More Info
below and follow the on-screen
instructions you may not be able to properly use
the application.
To Next Page
Loading...
