Samsung Galaxy Note II - Initial Device Configuration

Get Started 3
3. PlugtheUSBconnectorintothecharger/accessoryjackonthebottomofyourphone.
Warning! Whilethephoneischarging,ifthetouchscreendoesnotfunctionduetoanunstable
powersupply,unplugtheUSBpoweradapterfromthepoweroutletorunplugtheUSBcablefrom
thephone.
4. PlugtheACadapterintoanelectricaloutletandchargeyourbattery.Fullychargingabattery
maytakeuptothreehours.
Note: Yourphone’sbatteryshouldhaveenoughchargeforthephonetoturnonandfindasignal,
runthesetupapplication,setupvoicemail,andmakeacall.Youshouldfullychargethebatteryas
soonaspossible.
5. PressandholdthePowerbuttontoturnthephoneon.
l Ifyourphoneisactivated,itwillturnon,searchforSprintservice,andbeginthesetup
application.
l Ifyourphoneisnotyetactivated,seeActivateYourPhoneformoreinformation.