Samsung HL-R4667W - Page 114

Operation Instruction & Installation
Samsung Electronics 11-3
11-1-4 Rear Panel Jacks
Use the rear panel jacks to connect components such as a VCR. You can connect different components such as VCRs, Set-Top
Box and a DVD player etc., because there are two sets of video input jacks and two sets of component video input jacks on the
rear panel of your TV. For more information, see "Connections".
① ANTENNA terminals
Two independent cables or antennas can be connected to these
terminals. Use "ANT1 IN (CABLE)" and "ANT2 IN (AIR)" terminals
to receive a signal from VHF/UHF antennas or your cable system.
② SERVICE
This jack is for software upgrades..
③ S-VIDEO INPUT jacks
Connects an S-Video signal from an S-VHS VCR or DVD player.
④ DVI (Digital Video Interface) AUDIO INPUT jacks
Connect to the digital audio output jacks of a device with DVI
output.
⑤ PC AUDIO INPUT jacks
Connect these to the audio output jacks on your PC.
⑥ VIDEO/AUDIO INPUT jacks
Connect video/audio signals from external sources, such as VCR
or DVD players.
⑦ VIDEO/AUDIO OUTPUT jacks
Sends video/audio signals from the TV to an external source,
such as a VCR. These jacks are available only in RF, Video and
S-Video modes.
⑧ COMPONENT1, 2 jacks (Y, PB, PR, L, R)
Use these jacks to connect the component video/audio signals
from a DVD player or a Set-Top Box.
⑨ DIGITAL AUDIO OUT(OPTICAL) jack
Connect to a Digital Audio Component.
⑩ G-LINK™
Connect the IR controller cable to the G-LINK™ terminal on your
TV.
⑪ Anynet
Please refer to the Anynet Owner's Instruction.
⑫ PC VIDEO INPUT jack
Connect these to the video output jack on your PC.
⑬ HDMI (High Definition Multimedia Interface)/
DVI INPUT jack
Connect to the HDMI jack of a device with HDMI output.
These inputs can also be used as a DVI connection with separate
analog audio inputs. An optional HDMI/DVI cable will be
necessary to make this connection. When using the optional
HDMI/DVI adapter, the DVI analog audio inputs on your TV allow
you to receive left and right audio from your DVI device.
⑭ D-NET (IEEE1394) S400 MPEG
Connect to external IEEE1394 digital products.
Two jacks are provided for this purpose, which allow for a high
degree of flexibility for connecting your D-Net controlled system.
⑮ CableCARD™
Insert the CableCARD into the slot.
www.freeservicemanuals.info
9/13/15
Published in Heiloo, Holland.