Samsung HL-R4667W - How to Access Service Mode

Alignment & Adjustment
3-2 Samsung Electronics
3-2 How to Access Service Mode
1. Turn off the power to put the unit into the STAND-BY mode.
2. In order to enter the Service Mode, Press "Mute" → "1” → "8" → "2" → "POWER" button on the Remote Control.
In case entry into SERVICE MODE is unsuccessful, repeat the procedures above.
3. Initial DISPLAY State in times of Service Mode Switch overs
4. Buttons operations within Service Mode
DDP1011(L6)
DNIe
ADV7401(M)
ADV7401(S)
Xilleon226
uPD64083
MSP4440
CCA(ON)
Cinema CCA
SP Actuator
ESP
CHECKSUM 0000
OPTION
SERVICE
T_HUR2AUS0_XXXX
200X_XX_XX
T-HURUCOM5-XXXX
T-HUR2AUS1_XXXX
MENU Full Menu Display / Move to Parent Menu
Direction keys ▲ / ▼
Item Selection by Moving the Cursor
Direction keys ◀ / ▶
Data Increase/Decrease for the Selected Item
Source Cycles through the active input source that are connected to the unit
www.freeservicemanuals.info
9/13/15
Published in Heiloo, Holland.