Samsung HL-R4667W - Troubleshooting Procedures by Error Modes

Troubleshooting
Samsung Electronics 6-7
6-2 Troubleshooting Procedures by Error Modes
6-2-1 Installation & Connection
POWER
Press to turn the TV on and off.
Remote Control Sensor
Aim the remote control towards this spot on the TV.
● : Light is On
◑ : Light is Blinking
○ : Light is Off
TIMER LAMP STAND BY/TEMP Indication
○ ○ ●
Standby state.
○ ◑ ○
The picture will automatically appear in about 15 seconds.
● ◑ ○
Auto Timer ON/OFF has been set and the set will automatically be turned on in about 25
seconds.
◑ ○ ◑
A cooling fan inside the set is not operating normally.
○ ◑ ◑
Lamp cover on rear of the set is not properly shut.
○ ○ ◑
Check if the ventilation hole on the rear of the set is blocked, because if the inner
temperature is too high, the power will shut off.
◑ ◑ ◑
Lamp may be defective.
＊ It takes about 30 seconds for the TV to warm up, so normal brightness may not appear immediately.
＊ The TV has a fan to keep the inside lamp from overheating. You'll occasionally hear it working.
www.freeservicemanuals.info
9/13/15
Published in Heiloo, Holland.