Samsung HT-C9950W - Page 22

22 English
Getting Started
Fit the stand pole into the cable hole on the top
(silver) side of the stand base.
- Align the groove in the pole with the groove in
the stand base.
Fix the stand pole to the base with three (3) M13
x L15 screws.
- These are the longest screws in the Control
Unit screw pack.
- The three screw holes form a triangle in the
center of the base bottom.
4.
5.
Pull the cable through the bottom so that 3 1/2
to 4 feet protrudes through the top.
3.
3
4
Bottom
(Stand Base)
5
Push the smaller plug on the system cable
through the cable hole in the bottom of the
base.
- The fi t might be tight and you may have to
wiggle it through or use some force.
CAUTION
The stand base is heavy.
2.
!

2
Stand the pole and stand combination up on
the fl oor, silver side up, and then place the Deco
Stand Rear into the hole in the base top.
6.
6
Deco-stand Rear
3 1/2 ~ 4 feet
HT-C9950W_XAA_0820.indd 22HT-C9950W_XAA_0820.indd 22 2010-08-20  3:46:032010-08-20  3:46:03