Samsung HT-C9950W - Page 23

English 23
01 Getting Started
Fix the Control Unit to the Stand Pole using 2
silver M4 x L6 screws.
8.
8
Press the cable into the notch that runs the
length of the stand pole.
- The top is a tight fi t and you may have to use
some force.
11.
Squeeze the spring releases on the sides
of the small plug, and then attach it to the
system jack in the well on the bottom of the
Control Unit.
- Leave some slack in the cable.
Press the cable into the cable holder in the
Control Unit near the plug.
9.
10.
9
11
10
7. Fit the clasps on the Control Unit bottom into
the notches on the Stand Pole Bracket.
7
HT-C9950W_XAA_0820.indd 23HT-C9950W_XAA_0820.indd 23 2010-08-20  3:46:052010-08-20  3:46:05