Samsung HT-D5350 - Speaker Components; Installing the Speakers on the Tallboy Stand

20 English
Connections
Speaker Components Assembled Speakers
Installing the Speakers on the Tallboy Stand
Turn the Stand Base upside-down and connect it
to the Stand.
Insert small screws (4x20, For connecting Stand &
Stand Base) clockwise into the four holes marked
using a screwdriver as shown in the illustration.
CAUTION
When you use a torque screwdriver, be careful not
to put excessive force. Otherwise, it runs idle or
can be damaged. (torque screwdriver- below 15
kg.f.cm)
Connect the upper Speaker to the assembled
Stand.
Insert another large screw (5x15, For connecting
Speaker & Stand) clockwise into the hole on the
rear of the speaker using a screwdriver.
This is the appearance after the speaker is
installed. Follow this steps to install other speaker.
1.
2.
!

3.
4.
5.
4
2
Stand
Stand
Base
1
3
Stand
Speaker
5
CENTER
STAND
STAND BASE

SCREW (5X15): 4EA
SCREW (4X20): 16EA
SPEAKER CABLE
SUBWOOFER FRONT/ SURROUND SPEAKER
FRONT
(L) (R)
SUBWOOFERSURROUND
(L) (R)
CENTER SPEAKER
HT-D5350_XAC_0221.indd 20HT-D5350_XAC_0221.indd 20 2011-02-22  12:55:092011-02-22  12:55:09