English 17
02 Connections
Installing the Speakers on the Tallboy Stand
* HT-D553 only - Front Speakers
* HT-D555 only - Front/Surround Speakers
Turn the Stand Base upside-down and connect it to the Stand.
Insert small screws (4*20, For connecting Stand & Stand Base) clockwise into
the four holes marked using a screwdriver as shown in the illustration.
CAUTION : When you use a torque screwdriver, be careful not to put
excessive force. Otherwise, it runs idle or can be damaged. (torque screw-
driver- below 15 kg.f.cm)
Connect the upper Speaker to the assembled Stand.
Insert another large
screw (5*15, For connecting Speaker & Stand)
clockwise into the hole on the rear of the speaker using a
screwdriver.
This is the appearance after the speaker is installed. Follow this steps
to install other speaker.
1.
2.
!
3.
4.
5.
2
3
Stand
Speaker
4
Stand
1
Stand
Base
5
HT-D550-ZA-ENG-1228.indd 17HT-D550-ZA-ENG-1228.indd 17 2011-12-29 1:07:372011-12-29 1:07:37
To Next Page
Loading...
