Samsung HT-D6759W - Speaker Components; Installing the Speakers on the Tallboy Stand

18 English
Connections
Speaker Components
CENTRE
SUBWOOFER
SPEAKER CABLE
SURROUND
(L) (R)
Installing the Speakers on the Tallboy Stand
Turn the Stand Base upside-down and connect
it to the Stand.
Insert small screws (4x20, For connecting Stand
& Stand Base) clockwise into the four holes
marked using a screwdriver as shown in the
illustration.
CAUTION
When you use a torque screwdriver, be careful
not to put excessive force. Otherwise, it runs
idle or can be damaged. (torque screwdriver-
below 15 kg.f.cm)
Insert the large screw (5x15, For connecting
Stand & Stand Base) clockwise into the hole on
the rear of the stand using a screwdriver.
Connect the upper Speaker to the assembled
Stand.
Insert another large screw (5x15, For connecting
Speaker & Stand) clockwise into the hole on the
rear of the speaker using a screwdriver.
This is the appearance after the speaker is
installed.
Follow this steps to install other speaker.
1.
2.
!

3.
4.
5.
6.
SWA-5000
Wireless Receiver Module
TX Card
Speaker Cable (2EA)
STAND BASE
SCREW (4x20): 16EA
SCREW (5x15): 8EA
FRONT/FRONT TOP
(L) (R)
STAND
2
Stand
Stand Base
1
3
65
Stand
Speaker
4
or
HT-D6759W_ZG_0323.indd 18HT-D6759W_ZG_0323.indd 18 2011-03-23  10:02:442011-03-23  10:02:44