15
Connecting the Speakers
Connect the front, rear and center speakers to the speaker output jack on the side of subwoofer.
Bottom of Main unit
(HT-DS1000)
Rear of Subwoofer (PSWS1000E)
Center Speaker
Green
Gray
Red
Blue
White
Rear Speaker (L)
Rear Speaker (R)
Front Speaker (L)
Front Speaker (R)
Subwoofer: The subwoofer is active, with a built-in a 150W amplifier, and
outputs rich bass through 8 inch speaker units. You can listen to
the optimal LFE (bass) by using the subwoofer-only volume
control and the variable crossover control.
•
The control is calibrated from –6dB (minimum) to +6dB (maximum).
Crossover: The Crossover sets the cutoff frequency for the subwoofer. Set the
Crossover control for the best bass response in your room.
•
You can adjust the bass or treble output from the front, rear,
center speakers and the subwoofer.
•
To the left increases the bass and to the right, treble.
Connecting Main Unit to Subwoofer
Subwoofer Function
Use the supplied DIN audio connection cable to connect DIN
Audio Out on the main unit to DIN Audio Input on the
subwoofer.
Press the subwoofer power button on the subwoofer to turn
on the power.
1
2
HT-DS1000
1p~44p(DS1000)-GB 9/16/04 9:14 AM Page 18
To Next Page
Loading...
