Samsung HT-P1200 - Installation and Cable Management; Assembling the DVD Player Stand; Cable Routing and Organization

GB
11
2
1
Combine the round board
and the stand with the
screws (4).
Insert two screws in the top
holes, but only screw them in
1/2 way.
3
Align the stand with the two
screws.
4
Fully tighten the screws to
secure the stand to the DVD
player.
5
Insert the remaining four
screws & tighten.
Round Board
Stand
2
1
Push the cables connected to the
HDMI OUT, Component OUT, Video
OUT ports into the groove shown
in figure 1 using the Wire Hanger.
Push the cables connected to the
Audio IN, Anynet IN/OUT, Optical
Digital Audio IN and Audio OUT ports
into the groove shown in figure 2.
3
Open the holder cover of the round
board on the bottom of the stand and
pass the cables through the holder.
4
Squeeze the cables into the groove on
the holder of the round board.
5
Close the holder cover.
•
Keep the main unit and speakers out of the reach of children as the
equipment could tip over.
Caution
Installing the DVD player
Tidying Cables Up
Round Board Holder
Rear Side of
the Main Unit
Wire Hanger
1
2
12
CONNECTIONS