Speaker Components
Front/Rear Tallboy Stand (HT-TX715 only)
SPEAKER STAND BASESTAND SCREW (Small) :
16EA
SCREW (Large) :
4EA
Turn the STAND upside-down and connect it to the STAND BASE.
Turning the SCREW (Small) clockwise, connect it to four holes marked with the
arrow using a screwdriver as shown in the illustration.
Connect the assembled stand to the SPEAKER.
Turning the SCREW (Large) clockwise, connect to a hole on the
screwdriver as shown in the illustration.
This is the successfully assembled speaker.
1.
2.
3.
4.
5.
1
2
3
How to Install the Speaker on the Stand
STAND
BASE
STAND
SPEAKER
STAND
4
5
Make sure that the TALLBOY type speaker should be installed on the fl at and stable area. Otherwise it may
fall down due to external shock.
M
`
To Next Page
Loading...
