GB
CONNECTIONS
1312
Speaker Packages
Please confirm that all the following contents are included in the package.
Center Speaker
Subwoofer Speaker
Speaker Cable (5EA)Front/Rear Speaker (4EA)
Speaker Accessories
Speaker Installation
1 Turn the stand upside down and mount it on the stand
base.
2 Tighten 4 screws on the bottom side of the stand base.
3 Place the stand on the floor and tighten 2 screws on the
back of the stand.
4 Mount the speaker on the stand.
5 Tighten 2 screws on the back of the speaker.
6 This is the successfully assembled speaker.
How to Install the Speaker and the Stand
•
Make sure that the speaker is installed on a flat and
stable area. Otherwise it may be easily knocked over.
SPEAKER STAND Screw Screw
STAND BASE
1
6
3
4
2
5
*
Front speakers and rear speakers are
packaged separately as shown in the
diagram.
STAND
STAND
BASE
SPEAKER
STAND
Installing the DVD player
1 Mount the stand on the stand base and tighten 4
screws on the bottom side of the stand base.
2 Loosen 2 screws at the bottom of the back cover.
3 Detach the back cover by lifting it up.
4 Secure the main unit by aligning 4 protruding points
on the back of the main unit with the fixing holes
on the stand.
5 Tighten 2 screws in the middle of the stand.
6 Open a Toroidal Ferrite Core by pulling it upward.
Wrap it around of the system connection cable so it
will be next to the DVD Player. Close it back by press-
ing it all the way down until you hear a clicking sound.
7 Push the cable into the cable fixing hole in the stand.
8 To fix the cable, insert the cable holder into the hole on
the stand.
9 Let the cable run through the hole at the bottom
of the back cover and close the back cover.
10 Tighten 2 screws at the bottom of the back cover.
11 Open a Toroidal Ferrite Core by pulling it upward.
Wrap it around of the system connection cable so it
will be next to the DVD Player. Close it back by press-
ing it all the way down until you hear a clicking sound.
2
1
3
6 7
9
11
10
4 5
BACK COVER
Toroidal
Ferrite Core
System connection
cable - main unit
System connection cable -
Main Unit to Subwoofer
STAND
STAND
STAND BASE
STAND
BACK COVER
BACK COVER
8
Please confirm that all the following contents are included in
the package.
Stand Packages
• The Toroidal Ferrite Core is designed to reduce electromag-
netic waves that may cause interference.
STAND BASE
Screw (6EA)
Cable Holder (3EA)
To Next Page
Loading...
