6. AMP Pre-Inspection relating to Power Protection
6. AMP Pre-Inspection relating to Power Protection
If you think, there are problems at the AMP PCB, you can check
the pcb without disassemble the set.
(Caution!! : Do not connect t he power cor d dur i ng bel l ow
t es t ! )
GND
5.1CH SPEAKER OUT
FRONT R
FRONT L
CENTER
REAR R REAR L
SET
Measurement Resistance using Tester
- Approximately -
CH HT-TXQ120
F/R CH 20kΩ
CENTER 20kΩ
SUBWOOFER -
If Measured Resistance is very different from
above numbers, There is a Problem.
AMP PCB Problem
To Next Page
Loading...
