AUX2 : Connecting an External Analogue Component
Analogue signal components such as a VCR.
Connect AUX IN 2 (Audio) on the Home Cinema to the Audio Out of the external analogue
component.
Be sure to match connector colours.
Press the AUX button on the remote control to select AUX2 input.
You can also use the FUNCTION button on the main unit.
The mode switches as follows :
DVD/CD DIGITAL AUX1 AUX2 USB BT AUDIO HDMI IN TUNER.
You can connect the Video Output jack of your VCR to the TV, and connect the Audio Output jacks of the VCR
to this product.
OPTICAL : Connecting an External Digital Component
Digital signal components such as a Cable Box/Satellite receiver (Set-Top Box).
Connect the Digital Input (OPTICAL) on the Home Cinema to the Digital Output of the external digital
component.
Press the AUX button on the remote control to select DIGITAL.
You can also use the FUNCTION button on the main unit.
The mode switches as follows :
DVD/CD DIGITAL AUX1 AUX2 USB BT AUDIO HDMI IN TUNER.
1.
~
2.
~
M
`
1.
2.
~
Optical Cable
(not supplied)
AUX2 : Rear Panel OPTICAL : Rear Panel
Audio Cable (not supplied)
If the external analogue
component has only one Audio
Out, connect either left or right.
External Analogue
Component
External Digital Component
CONNECTING THE FM ANTENNA
Connect the FM antenna supplied to the FM 75Ω COAXIAL Jack.
Slowly move the antenna wire around until you fi nd a location where reception is good, then fasten it
to a wall or other rigid surface.
This unit does not receive AM broadcasts.
Cooling Fan
The cooling fan supplies cool air to the unit to prevent overheating.
Please observe the following cautions for your safety.
Make sure the unit is well-ventilated. If the unit has poor ventilation, the temperature inside the unit
may rise and may damage it.
Do not obstruct the cooling fan or ventilation slots. (If the cooling fan or ventilation slots are covered
with a newspaper or cloth, heat may build up inside the unit and fi re may result.)
1.
2.
M
`
~
~
FM Antenna (supplied)
To Next Page
Loading...
