Samsung HT-Z210 - How to Install the Speaker on the Stand; How to Install the Speaker on the Stand Base

20
connections
Front/Rear Tallboy Stand
How to Install the Speaker on the Stand Base
Connect the SPEAKER with the
STAND BASE.
Insert the SCREW into the hole on the rear
of the speaker using a screwdriver as shown
in the illustration.
This is the SPEAKER successfully
assembled with the Stand Base.
1.
2.
3.
1 2
3
SPEAKER
STAND
BASE
The speaker system may vary, depending on the model. Please check your speaker system to
see if it includes the correct package of "Front/rear & Center Speakers" corresponding to
your model.
M
`
Turn the STAND upside-down and connect
it to the STAND BASE.
Insert two small SCREWS into the two holes
marked with arrows using a screwdriver as
shown in the illustration.
(HT-TZ215 : 2EA, HT-TZ315 : 3EA)
Insert a large SCREW into the hole on the
rear of the Speaker STAND.
Connect the assembled stand to the
SPEAKER.
Insert another large SCREW into the hole on
the rear of the speaker using a screwdriver
as shown in the illustration.
This is the successfully assembled speaker.
Make sure that the speaker is installed on a
fl at and stable area. Otherwise it may be
easily knocked over.
1.
2.
3.
4.
5.
6.
1 2
3 4
5 6
How to Install the Speaker on the Stand
STAND
BASE
STAND
SPEAKER
STAND
The speaker system may vary, depending on the model. Please check your speaker system to
see if it includes the correct package of "Front/rear & Center Speakers" corresponding to
your model.
M
`
HT-Z310-CIS-ENG-0403.indd 20 2008-04-03 �� 7:10:50
Downloaded From TheatreSystem-Manual.com Manuals