Samsung HW-E450 - Advanced Functions; Speaker Button Functionality; Using TV Functions with Remote; Software Upgrade Procedure

SPEAKER button
This button enables you to select between listening to audio from your
TV or audio from the Air Track when connected via HOM I.
Press SPEAKER on the remote control of this unit.
AUDIO MODE SPEAKER Scroll Display
Display
HDMIIN
lV lVSPEAKER
lVSPK
Air Track AVRSPEAKER
HOM I
ARC
lV lVSPEAKER SMUTE
Air Track AVRSPEAKER lVARC
Using the TV functions
1. Press TV SOURCE on the remote control of this unit.
2. Press TV INFO on the remote control to display the TV channel
information.
3. Press TV CH on the remote control to select the TV channel.
4. Press TV VOL on the remote control to increase or decrease the volume
level.
5. Use TV PRE-CH button to move to the prev i ous TV channel in TV
mode.
6. To exit the TV menu, use the TV EXIT button. (F unctions same as the
EXI T button of the TV remote control)
• The remote control can operate TVs made by SAMSUNG only .
SOFTWARE UPGRADE
Sam sung may offer upgrades fo r t he Crystal
Surround Air Track's syste m fi rm ware in the future .
If
an upgrade is offered, you can upgrade the
firmware by connecting a US B drive with the
firmwa re upgrade stored on it to the US B port on
your Air Track.
Note that if there are mul t iple upgrade files, you must
load them onto the US B drive singly and use them to
upgrade the firmware one at a time.
Please visit Samsung . com or contact the Samsung
call center to receive more information about
downloading upgrades files.
22
• Insert a USB drive containing the firmware upgrade into the USB port on the back of the main unit.
• Please be careful to not disconnect the power or remove the USB drive while upgrades are being
applied. The main unit will turn off automatically after completing the firmware upgrade.
When software is upgraded, settings you have made will return to their default (factory) settings.
We recommend you write down your settings so that you can easily reset them after the upgrade.
If the firnware fails to upgrade, we recommend formatting the USB data in FAT16 and trying again.
" For upgrading purposes, do not format the USB drive in NTFS format because it is not a supported file system.
Depending on the manufacturer, the USB may not be supported.