19
ENG
● FUNCTIONS
Using the AUTO POWER LINK function
The Wireless Audio - Soundbar is automatically turns on when you turn on
the TV or any other device connected to the Soundbar with the optical
cable.
Press AUTO POWER on the remote control of this unit.
• The Auto power link function turns on and off each time you press AUTO
POWER.
AUTO POWER LINK Display
ON
POWER LINK ON
OFF
POWER LINK OFF
Using the DIMMER function
This feature control the brightness of the Display.
Press DIMMER on the remote control of this unit.
Each time the button is pressed, the selection changes as follows :
DIMMER ON
➡
DIMMER OFF
Using the AUDIO SYNC function
Video may appear out of synch with the audio if the Soundbar is
connected to a digital TV. If this occurs, adjust the audio delay time to
match the video.
Press AUDIO SYNC +/–. on the remote control of this unit.
• You can use the + , - buttons to set the audio delay time between 0
ms and 300 ms.
In USB mode TV mode or BT mode, the Audio Sync function
may not work.
Using the TONE function
Press TONE on the remote control of this unit.
• Each time the button is pressed, the selection changes as follows :
TREBLE ➡ BASS.
Press VOL + or VOL - button to increase or decrease
the Treble or Bass volume. You can set the Tone setting for each from
-3 to +3.
AUX TV SOURCEOPTICAL
AUTO POWER
SoundConnect
USB/
REPEAT
TV VOL TV CH AUDIO SYNC
TV PRE CH
TV EXIT
TV INFOTV MUTE
LEVEL LEVEL
VOL
3D SOUND
PLUS
MUTE
TV PRE-CH
DIMMER
SMART VOLUMESOUND EFFECT
TV INFOTV MUTE
To Next Page
Loading...
