Press button to listen to an Internet radio station.
Each time you press this button, the Soundbar switches to the next default
station, cycling through the 3 default stations.
To use the function, the soundbar must be connected
to the network. (See page 25)
Lets you apply dynamic range control to Dolby Digital.
Press and hold the button, then the DRC (Dynamic
Range Control) function toggles between and .
(* Use the
[
,
]
buttons to adjust woofer volume.)
Press the button. Then, use the
[
,
]
buttons to adjust
Subwoofer volume from -12, -6 to +6.
You can also activate function of the soundbar by pressing and
holding button of the remote for over 5 seconds.
Surr.Sound adds depth and spaciousness to the sound. Pressing the
button repeatedly cycles through the Surr.Sound settings :
,
Adjusts the volume level of the unit.
Turns the Soundbar on and off.
You can select the sound modes - ,,
,,, and - depending on the
content you want to listen to.
Select the mode if you want to enjoy the original sound.
Press the
p
button to pause the playing of a file temporarily.
Press the
p
button again to play the selected file.
If there is more than one file on the device you are playing, and you press
the
[
button, the previous file is selected.
Use a suitable coin to turn the
remote control's battery cover
counterclockwise to remove it
as shown in the figure above.
Insert a 3V lithium battery. Keep the
positive (+) pole facing up when
inserting the battery. Put the battery
cover on and align the '●' marks side
by side as shown in the figure above.
Use a suitable coin to
turn the remote control
battery cover clockwise
as far as it will go to fix
it in place.
To Next Page
Loading...
