Samsung HW-Q910B - Page 5

04 USING A WIRED
CONNECTION
~ HDMI Cable
NOTE
Connecting using an HDMI Cable
(External Device (HDMI) / TV ARC / eARC)
Connecting using an Optical Cable (D.IN)
•
When the TV sound is not output, press the O (Multi
Function) button at the top of the Sound bar or the
~ (Source) button on the remote control to select the
"D.
IN " mode. The screen displays "D. IN " and " TV ARC /
eAR C" in sequence, and TV sound is played.
•
The recommended cable is High Speed HDMI Cable with
Ethernet.
• When you use an optical cable and the terminals have
covers, be sure to remove the covers.
Using the Q-Symphony Function
For Q-Symphony, the Sound bar sy n cs with a Samsung TV to
output sound t h rough two devices fo r optimum surround
effect.
When the Sound bar is connected, the menu,
" TV+Soundbar " appears under the Sound Output menu of
the TV . (The message above differs with the TV model.)
•
TV menu example: TV+ [ AV] Sound bar ser ies na me
(HDM I/ Wi - Fi)
NOTE
• It can operate according to the Codec supported by TV.
• This function is supported only when the HDMI Cable or
Optical
Cable (not supplied) or Wi-Fi is connected.
•
The message displayed may differ with the TV model.
• Ensure that your TV and Sound bar are connected to the
same wireless router/frequency.
•
This function is available in some Samsung TVs and
some Sound bar models.
Using the Spacefit sound
Provides optimized sound quality by analyzing the listening
spaces.
05 USING A WIRELESS
CONNECTION
Connecting via Bluetooth
Top of the Sound bar
OR
D
.. t··
OR
What is the difference between BT READY and BT
PAIRING?
• BT READY : In this mode, you can reconnect any
Samsung TV or mobile device that was connected
before.
•
BT PAIRING : In this mode, you can connect a new device
to the Sound bar.
(Press the * PA IR button on the Sound bar remote
control or
press and hold the 0 (Mic On / Off) button on
the top of the Sound bar for more than 5 seconds while
the
Sound bar is in "B T" mode.)
NOTE
• If asked for a PIN code when connecting a Bluetooth
device, enter < 0000 >.
Connecting via Wi-Fi (Wireless
Network)
• To connect a Sound bar to a mobile device via a wireless
network (Wi-Fi), the
SmartThings app is required.
1. Connect your mobile device (smartphone, tablet, etc.) to
the Wi-Fi network the TV is connected to.
2. Install and launch the SmartThings app on your mobile
device (smartphone, tablet, etc.).
3. Follow the instructions in the
app screen on the mobile
device to connect the Soundbarto yourWi-Fi network.