66
GETTING STARTED
Using your new SVM/SVMi E-Series Subscriber Services is as simple as fol-
lowing a few simple spoken instructions. First time users should read this
section as a tutorial. You should start with the following steps:
• Access your Subscriber Services Menu - You already know how to do
this.
From the Subscriber Services Menu:
• Record a Primary/No-Answer Personal Greeting. Dial [5][1].
• Record a Mailbox Greeting. Dial [5][7].
• Change your access code (Password). Dial [#][7][1].
• Record your name. Dial [#][7][2].
• Enter your directory name. Dial [#][7][3].
After you have completed the steps above your Subscriber Services are set
up and ready to use.
LISTENING TO YOUR MESSAGES
If there are new messages in your mailbox your [VMMSG] key will be lit. Call
the SVM/SVMi E-Series by pressing this key, and when prompted enter your
password. You will then be at the Subscriber Services Menu. Select [1] to
listen to new messages or [3] to listen to saved messages.
Note: After you enter your password, if “Autoplay of New Messages” is
enabled and you have new messages the SVM/SVMi E-Series will begin to
play them automatically. A subscriber can control this feature. From the
Subscriber Services Menu [6] [5] toggles “Autoplay of New Messages”
ON/OFF.
1 LISTENING TO NEW MESSAGES
11 GROUP NEW MESSAGES
2 RECORD AND SEND A MESSAGE
3 LISTENING TO OLD MESSAGES
33 GROUP OLD MESSAGES
4 ACCESS MANAGER
5 PERSONAL GREETINGS
6 MAILBOX ADMINISTRATION
8 PAUSE / RESUME
0 PLAY MENU OPTIONS
idcs100_falcon.qxd 10/20/2004 12:43 PM Page 72
To Next Page
Loading...
