●
Positioner Settings: Configures the aerial positioner.
Try Now
Positioner: Enables or disables the positioned control.
Positioner Type: Sets the positioned type between DiSEqC 1.2 and USALS (Universal Satellite
Automatic Location System).
–
My Longitude: Sets the longitude for my location.
–
My Latitude: Sets the latitude for my location.
–
Satellite Longitude Settings: Sets the longitude of user defined satellites.
User Mode: Sets the position of satellite aerial according to each satellite.
If you store the current position of satellite aerial according to a certain satellite, when the signal
of that satellite is needed, the satellite aerial can be moved to pre-populated position.
–
Satellite: Selects the satellite to set the position for.
–
Transponder: Selects a transponder from the list for signal reception.
–
Moving Mode: Selects the movement mode between discrete and continuous movement.
–
Step Size: Adjusts the step size degrees for the aerial rotation. Step Size is available when
Moving Mode is set to Step.
–
Go To Stored Position: Rotates the aerial to the stored satellite position.
–
Aerial Position: Adjusts and stores the aerial position for the selected satellite.
–
Store Current Position: Stores current position as the selected positioner limit.
Installer Mode: Sets limits to the scope of movement of satellite aerial or reset the position.
Generally, installation guide uses this function.
–
Limit Position: Selects the direction of the positioner Limit.
–
Aerial Position: Adjusts and stores the aerial position for the selected satellite.
–
Store Current Position: Stores the current position as the selected positioner Limit.
–
Go to zero: Moves the aerial to the reference position.
–
Reset positioner limit: Allows the aerial to rotate over the full arc.
●
Reset All Settings: All satellite settings will be reset to the initial values.
Try Now
To Next Page
Loading...
