43
Connecting to MDC
Using MDC via RS-232C (serial data communications
standards)
An RS-232C serial cable must be connected to the serial ports on the PC and monitor.
―
The appearance may differ depending on the product.
RS232C OUT
RS232C IN
RS232C IN
RS232C OUTRS232C IN
Monitor 1
Monitor 2
Computer
Using MDC via Ethernet
Enter the IP for the primary display device and connect the device to the PC. Display devices can be
connected to each other using a LAN cable.
Connection using a direct LAN cable
―
The appearance may differ depending on the product.
―
Multiple products can be connected using the RJ45 (LAN OUT) port on the product and the LAN ports on the
HUB.
RJ45 (LAN OUT)
HUB
Monitor 1
Monitor 2
Computer
To Next Page
Loading...
