Need help?Do you have a question about the Samsung LH008IWJ Series and is the answer not in the manual?
Guidance on dehumidification process during LED display installation for quality preservation.
Guidance on dehumidification process during LED display operation to prevent electrical shorts.
Explains dew condensation risk due to overcooling and its potential impact on product defects.
Instructions on how to download and update the latest firmware for the LED display.
Essential checks before installation, including cable connections and cabinet compatibility.
Compatibility table for S-Box, SNOW-1810U, and related cabinet models.
Detailed specifications for different LED display models (pitch, resolution, brightness, etc.).
Overview of screen configuration and component details based on display model and pitch.
Critical precautions to prevent LED damage during installation from impacts, static, or chemicals.
Guidelines and cautions for safely cleaning the LED display screen to avoid damage.
Defines standards and conditions for indoor installation related to radiant heat and environment.
Specifies minimum required spacing for buried installation to manage heat and air circulation.
Details minimum spacing requirements for landfill installations with fan considerations.
Steps for unpacking and initial preparation of LED cabinets before installation.
Procedure for dehumidifying LED modules to protect them from moisture damage.
Steps for performing a screen check using internal patterns and toggle switches.
Lists all components included in the frame kit for LED display installation.
Instructions for assembling the frame brackets (side, middle, horizontal) for installation.
Important precautions regarding screw fastening methods based on wall types.
Guidance on extending the frame horizontally and vertically for larger display configurations.
Procedure for installing the I/G (Interface Gender) on the back of LED cabinets.
Steps for installing LED cabinets onto the frame, including alignment and sliding.
Details on adjusting the Z-step for half-cabinets to ensure proper alignment and gap.
Instructions for aligning LED modules in X and Y directions using cover PCBs and holder PCBs.
Steps for removing the bezel, cover, and holder PCB for front service access.
Guidance on using absorber tools and magnet jigs for safe handling and module manipulation.
Detailed procedures for disassembling half-cabinets, including edge protection.
Safety precautions and steps for disassembling the SMPS (Switch Mode Power Supply).
General standards and cautions for connecting power and OCM cables to LED cabinets.
Defines data flow standards for OCM cable connection in FHD configurations (IW008J, IW012J, IW016J).
Illustrates OCM cable connection standards for 2x2, 3x3, and 4x4 FHD configurations.
Precautions for installing the S-BOX in server racks and on walls, including ventilation.
Step-by-step guide for connecting video signals, HDBT, and OCM cables to the S-BOX.
Instructions for configuring S-BOX picture settings based on display model and panel layout.
Guide on enabling and configuring S-BOX grouping via LSM for video wall setup.
Instructions for enabling Simple Wall Mode in the S-BOX factory menu for wallpaper display.
Information on downloading and using the LED Signage Manager (LSM) software.
Guide for setting up network IP addresses and connecting the S-BOX via RS232 or RJ45.
Overview of the LSM main window, covering device info, layout, and fault status.
Procedures for calibrating LED cabinets using colorimeters or mobile devices.
Instructions on how to initiate and manage the dehumidification process using the LSM software.
Overview of on-site calibration functions using measurement equipment or mobile devices.
Steps for calibrating LED displays using a colorimeter and the Color Expert LED software.
Guide for performing color calibration using the Color Expert LED mobile application.
Instructions for attaching the frame bezel to the LED display cabinets.
Methods for extending the frame bezel vertically and side-by-side for larger configurations.
Explains the operating principle of attaching LED modules using a magnetic jig.
List of certified HDBaseT cables recommended for stable signal transmission.
To Next Page
General