English - 51
The following settings are to use Anynet+ functions.
Using the Anynet+ Function
1. Press the Anynet+ button.
Press the ▲ or ▼ button to select Setup, then press the ENTER button.
2. Press the ENTER
button to select Anynet+ (HDMI-CEC), then press the ENTER button.
3. Press the ▲ or ▼ button to select On
, then press the ENTER button.
The Anynet+ (HDMI-CEC) function is enabled.
If you select Off, Anynet+ (HDMI-CEC) is disabled.
When the Anynet+ (HDMI-CEC) function is disabled, all the Anynet+ related operations
are deactivated.
Turning an Anynet+ Device Off Automatically when the TV is Turned Off
1. Pre
ss the ▲ or ▼ button to select Auto Turn Off, then press the ENTER button.
2. Press the ▲ or ▼ button to select On, then press the ENTER button.
The Auto turn off function is enabled.
If you select Off, the Auto turn off function is canceled.
Press the EXIT button to exit.
The Select Device setting of the TV remote control is to be set to TV to use the Anynet+
function.
If you set Auto Turn Off to On, connected external devices are also turned off when the
TV is turned off. However, if the device is recording, it may not be turned off.
➣
➣
➣
➣
➣
➣
➣
1. Press the Anynet+ button.
2. Press the ▲ or ▼ button to select Select Device, then press the ENTER button.
3. Press the ▲ or ▼ button to select to a particular device and press the ENTER button.
It is switched to the selected device.
4. If you cannot find a device you want, press the ▲ or ▼ button to select Searching
Connections, then press the ENTER button.
The meassage Configuring Anynet+ connection... is displayed. When searching
devices completes, the connected devices are listed in the Anynet+ menu.
Switching to the selected devices may take up to 2 minutes. You cannot cancel the
operation during the switching operation.
The time required to scan for devices is determined by the number of connected
devices.
When the device scan is complete, the number of found devices is not displayed.
Although the TV automatically scans devices when it is turned on using the POWER
button, devices connected when the TV is on or under a specic circumstance are not
displayed in the device list. Therefore select Searching Connections menu to search
devices.
If you have selected external input mode by pressing the SOURCE button, you cannot
use the Anynet+ function. Make sure to switch to an Anynet+ device by using the
Anynet+
button.
➣
➣
➣
➣
➣
Enter
Move
View TV
Select Device
Record
Menu on Device
Device Operation
Receiver :Off
Setup
Air 28
Exit
Setup
Anynet+ (HDMI-CEC)
: Off
Auto Turn Off
: Off
Searching Connections
Enter ReturnMove
Off
On
Setup
Anynet+ (HDMI-CEC)
: On
Auto Turn Off
: Off
Searching Connections
Enter ReturnMove
Off
On
Setup
Anynet+ (HDMI-CEC)
: On
Auto Turn Off
: On
Searching Connections
Enter ReturnMove
Enter
Move
View TV
Select Device
Record
Menu on Device
Device Operation
Receiver :Off
Setup
Air 28
Return
DVDR1
DVDR2
DVD1
DVD2
Setting Up Anynet+
Scanning and Switching between Anynet+ Devices
To Next Page
Loading...
