Samsung MAX-6020 - Inserting Remote Control Batteries; Viewing the Various Functions on Your System; Setting the Clock

GB
9
Insert or replace remote control batteries when you:
Purchase the mini-compact system
Find that the remote control is no longer operating correctly
When replacing the batteries, use a new set of batteries and
never mix alkaline and manganese batteries.
Place your thumb on the position marked on the battery compart-
ment cover (rear of the remote control) and push the cover in the
direction of the arrow.
Insert two AAA, LR03 or equivalent batteries, taking care to respect
the polarities:
+ on the battery against + on the remote control
– on the battery against - on the remote control
Replace the cover by sliding it back until it clicks into position.
You can view the various functions available on your system.
Press the Demo button.
Result: The various functions available are listed in turn on the dis-
play.
All these functions are described in detail in this booklet.
For instructions on how to use them, refer to the appropriate
sections.
To cancel this function, press Demo again.
Your system is equipped with a clock which allows you to
turn your system on and off automatically. You should set the
clock:
When you purchase the mini-compact system
After a power failure
After unplugging the unit
Remember to reset the time when the clock changes from
winter to summer time and vice verse.
For each step, you have a few seconds to set the required
options. If you exceed this time, you must start again.
Switch the system on by pressing On/Standby.
Press Timer/Clock twice.
Result:
CLOCK is displayed.
Press Enter.
Result:
The hour flashes.
To... Press
Increase the hours Tuning Mode Up
Decrease the hours Tuning Mode Down
When the correct hour is displayed, press Enter.
Result:
The minutes flash.
To... Press
Increase the minutes Tuning Mode Up
Decrease the minutes Tuning Mode Down
When the correct time is displayed, press Enter.
Result:
The clock starts and is displayed, even when the system is in
standby mode.
You can display the time, even when you are using another func-
tion, by pressing Timer/Clock once.
Setting the Clock
Viewing the Various Functions on
Your System
2
1
1
2
3
4
5
6
7
On/Standby
Demo
AI Off
/Sleep
TUNER C D TAPE AUX
+
–
Volume
Band
Mono/ST Memory Repeat Program Deck 1/2 REV mode
Normal
TAPE TAPE REC
HI-SpeedCD SYNC.REC/Pause
REC Lock
Shuffle
Tuning ModeDown Up
Timer
On/Off
Timer
/Clock
R
S
u
r
r
o
u
n
d
P
o
w
e
r
S
.
B
a
s
s
E
Q
M
u
t
e
E
n
t
e
r
On/Standby
Demo
AI Off
/Sleep
TUNER C D TAPE
Timer
On/Off
Timer
/Clock
R
Inserting Remote Control Batteries
1
2
3
1
2
3,5,7
4,64,6
MAX-6020/GB-1~14 5/20/03 16:51 Page 9