GB
10
You can view the various functions available on your system.
Press the Demo button.
Result: The various functions available are listed in turn on the
display.
All these functions are described in detail in this booklet.
For instructions on how to use them, refer to the appropriate
sections.
To cancel this function, press Demo again.
Your mini-compact system has an improved Moving Jog Function,
including visual effect on standard jog function.
Each time you press Tuner, CD or Tape buttons, Moving Jog will
move automatically to a selected function.
Moving Jog will always return to CD position at standby.
Be cautious not to move Moving Jog excessively or give extreme
force. It will likely be the major cause of malfunction.
Your system is equipped with a clock which allows you to
turn your system on and off automatically. You should set the
clock:
When you first purchase the mini-compact system
After a power failure
After unplugging the unit
For each step, you have a few seconds to set the required
options. If you exceed this time, you must start again.
Switch the system on by pressing On/Standby.
Press Timer/Clock twice.
Result:
CLOCK is displayed.
Press Enter.
Result:
The hour flashes.
To... Turn the Moving Jog knob to the...
Increase the hours Right
Decrease the hours Left
When the correct hour is displayed, press Enter.
Result:
The minutes flash.
To... Turn the Moving Jog knob to the...
Increase the minutes Right
Decrease the minutes Left
When the correct time is displayed, press Enter.
Result:
The clock starts and is displayed, even when the system is in
standby mode.
You can display the time, even when you are using another
function, by pressing Timer/Clock once.
You can also use Program/Set button on the remote control
to instead Enter button in step 3, 5, 7.
You can also use / buttons to instead Moving Jog
knob in step 4, 6.
Setting the Clock
2
1
1
2
3
4
5
6
7
To Next Page
Loading...
