Samsung MCM-D211UN - Page 29

29
ENGLISH
Example of IN/OUT sensor installation 2
1. Chcek the sensor and sensor holder you will attach.
Type
Diameter of a
sensor (in(mm))
Diameter of a sensor
holder (in(mm))
  
OUT sensor

 
NOTE
Insulator
 Rubber tape
IN/OUT
sensor
Cable tie
2. Attach the sensor closely to the pipe.
Attaching a sensor
• 

• 
surface of the pipe.
• Do not use a sensor holder.
NOTE
Sensor
Pipe
3. After attaching the sensor on the pipe, cover it with
aluminum tape.

IN/OUT
sensor
4. Cover the sensor with rubber tape.
Rubber
tape
IN/OUT sensor
5. Fix the sensor with cable ties.
Cable tie
6. Attach the insulator around the attached sensor.
Insulator
DB68-06643A-03_IM_ACC UCK Kit_AA_EN.indd 29DB68-06643A-03_IM_ACC UCK Kit_AA_EN.indd 29 2023-01-13 오전 11:35:132023-01-13 오전 11:35:13