Alignment & Adjustments
Service Manual
4-3
Samsung Electronics
Sensor Description Display (LCD) Remarks
Before touching After touching
RegiSensor
T1 FeedSensor
T2 FeedSensor
T3 FeedSensor
T4 FeedSensor
ExitSensor
DJam1Sensor
Out Bin Sensor
Bypass Empty
T1 Paper Empty
T2 Paper Empty
T3 Paper Empty
See the message after touching the sensor.
See the message after touching the sensor.
See the message after touching the sensor.
See the message after touching the sensor.
See the message after touching the sensor.
See the message after touching the sensor.
See the message after touching the sensor.
See the message after touching the sensor.
See the message after touching the sensor.
See the message after touching the sensor.
See the message after touching the sensor.
See the message after touching the sensor.
Regi. Sensor
[Without Paper]
T1 Feed Sensor
[Without Paper]
T2 Feed Sensor
[Without Paper]
T3 Feed Sensor
[Without Paper]
T4 Feed Sensor
[Without Paper]
Exit Sensor
[Without Paper]
DJam1 Sensor
[Without Paper]
OutBin. Sensor
[Normal]
Bypass Empty
[Empty]
T1 Paper Empty
[Empty]
T2 Paper Empty
[Empty]
T3 Paper Empty
[Empty]
Regi. Sensor
[With Paper]
T1 Feed Sensor
[With Paper]
T2 Feed Sensor
[With Paper]
T3 Feed Sensor
[With Paper]
T4 Feed Sensor
[With Paper]
Exit Sensor
[With Paper]
Djam1 Sensor
[With Paper]
OutBin Sensor
[Full]
Bypass Empty
[Present]
T1 Paper Empty
[Present]
T2 Paper Empty
[Present]
T3 Paper Empty
[Present]
4.1.4 Sensor Status
These Functions are to check a current state (normal or not) of each Sensor.
• Usage
- The other sensors
1. Press the
Arrow Keys ( ) until finding Component Test / 2.Sensor Status message on the panel.
2. Press the
OK Key , when it is found.
3. Press the
Arrow keys until finding a suitable function. (Refer to the table below)
4. Press the
OK Key , when it is found.
3. Touch a sensor you would like to test.
4. Check the message on the LCD window for the state of it.
• Function
To Next Page
Loading...
