Samsung MM-E430 - Setting the Clock

12 English
English 12
English 13
PS
(Program Service)
While searching, <PS> appears and
then the station names will be
displayed. <NO PS> appears if no
signal is sent.
RT(RadioText)
While searching, <RT> appears and
then text messages the station sends
will be displayed. <NO RT> appears if
no signal is sent.
CT (Clock Time)
Decodes the real time clock from the
FM frequency.
Some stations may not transmit PTY,
RT or CT information therefore this
may not be displayed in all cases.
Frequency
Station frequency (non-RDS
service).
About characters shown in the display
When the display shows PS,or RT signals,the
following characters are used.
•
The display window cannot differentiate upper
case and lower case letters and always uses upper
case letters.
• The display window cannot show accented letters,
<A,> for instance, may stands for accented <A’s> like
<À, Â, Ä, Á, Å and Ã.>
PTY(Program Type) indication and
PTY-SEARCH function(Optional)
One of the advantages of the RDS service is that you
can locate a particular kind of program from the
preset channels by specifying the PTY codes.
To search for a program using the PTY codes
Before you start!
• The PTY Search is only applicable to preset
stations.
• To stop searching any time during the process,
press the STOP button while searching.
• There is a time limit in doing the following steps.
If the setting is cancelled before you finish, start
from step 1 again.
• When pressing the buttons on the primary remote
control, make sure that you have selected the FM
station using the primary remote control.
1. Press the RDS PTY button while listening to an
FM station.
2. Press the TUNING/ALBUM , or . buttons
until the PTY code you want appears on the
display.
• ThedisplaygivesyouthePTYcodesdescribed
totheright.
3. Press the RDS PTY button again, while the PTY
code selected in the previous step is still on the
display.
• Thecentreunitsearches30presetFMstations,
stopswhenitndstheoneyouhaveselected,
andtunesinthatstation.
Setting the Clock
For each step, you have a few seconds to set the
required options. If you exceed this time, you must
start again.
1. Switch the system on by pressing the POWER
button.
2. Press TIMER SET button and then press the
ENTER button,"CLOCK” is displayed.
3. Press ENTER button.The hour flashes.
• Increasethehours:
,
.
• Decreasethehours:..
4. When the correct hour is displayed, press ENTER
button. The minutes flashes.
• Increasetheminutes:,,
• Decreasetheminutes:..
5. When the correct minute is displayed, press the
ENTER button. " TIMER" appears in the display.
• Thecurrenttimeissetnow.
• You can display the time, even when you are
using another function, by pressing the TIMER
SET button once.
• You can also use the
[
or
]
on the top panel
instead of the TUNING/ALBUM
,
or
.
buttons
in steps 3 and 4.