GB
13
The timer enables you to switch the system on or off at specific times.
Example: You wish to wake up to music every morning.
If you no longer want the system to be switched on or off
automatically, you must cancel the timer.
Before setting the timer, check that the current
time is correct.
For each step, you have a few seconds to set
the required options. If you exceed this time,
you must start again.
1 Switch the system on by pressing On/Standby.
2 Press Timer/Clock until TIMER is displayed.
3 Press Program/Set.
Result: ON TIME is displayed for a few seconds, followed
by any switch-on time already set; you can set the
timer switch-on time.
4 Set the timer switch-on time.
a Set the hour by pressing TUNING and .
b Press Program/Set.
Result: The minutes flash.
c Set the minutes by pressing TUNING and .
d Press Program/Set.
Result:OFF TIME is displayed for a few seconds,
followed by any switch-off time already set; you
can now set the timer switch-off time.
5 Set the timer switch-off time.
a Set the hour by pressing TUNING and .
b Press Program/Set.
Result: The minutes flash.
c Set the minutes by pressing TUNING and .
d Press Program/Set.
Result:VOL XX is displayed, where XX corresponds to the
volume already set.
6 Press TUNING and to adjust the volume level and
press Program/Set.
Result: The source to be selected is displayed.
7 Press TUNING and to select the source to be played
when the system switches on.
If you select... You must also...
TAPE (cassette) Insert a recorded cassette in the
decks before setting the system to
standby.
TUNER (radio) a Select the FM or AM frequency
band by pressing TUNING
and .
b Press Program/Set.
c Select a preset station by pressing
TUNING and .
CD (compact disc) a Load compact discs.
8 Press On/Standby to set the system to standby mode.
Result:
is displayed to the middle right of the time,
indicating that the timer has been set. The system will
switch on and off automatically at the required times.
If the timer switch on and off times are identical, the word
ERROR is displayed.
After having set the timer, it will start automatically as shown by
the indication on the display. If you no longer wish to use the
timer, you must cancel it.
You can stop the timer at any time (system on or in
standby mode).
To... Press Timer On/Off
Cancel the timer Once.
Result: is no longer displayed.
Restart the timer Twice.
Result: is displayed again.
Timer Function
To Next Page
Loading...
