|
20 English
Basic Functions
Setting the Clock
For each step, you have a few seconds to set the
required options. If you exceed this time, you must
start again.
1. Switch the system on by pressing the
POWER ( ) button.
2. Press and hold the TIMER/CLOCK button and
then press the
v
button.
Result:
"CLOCK" is displayed.
3. Press the
v
button.
Result:
The hour flashes.
`
Decrease the hours:
%
`
Increase the hours:
$
4. When the correct hour is displayed, press the
v
button.
Result:
The minutes flashes.
`
Decrease the minutes:
%
`
Increase the minutes:
$
5. When the correct minute is displayed, press
the
v
button.
Result: "
TIME" appears in the display.
`
The current time is now set.
| NOTE |
\
You can display the time, even when you are using
another function, by pressing and hold the TIMER/
CLOCK button once.
\
You can also use
[
,
]
on the front panel instead of
▼, ▲ buttons in step 3,4.
Timer Function
The timer enables you to switch the system on or
off at specific times automatically.
\
Before setting the timer, check that the current time is
correct.
\
For each step, you have a few seconds to set the
required options. If you exceed this time, you must
start again.
\
If you no longer want the system to switch on or off
automatically, you must cancel the timer by pressing
the TIMER ON/OFF button.
Example: You wish to wake up to music every
morning.
1. Switch the system on by pressing the
POWER ( ) button.
2. Press and hold the TIMER/CLOCK button and
then press the ▲ or ▼ buttons until
TIME is
displayed.
3. Press the
v
button.
Result: ON is displayed for a few seconds, you
can set the timer switch-on time.
4. Set the timer switch-on time.
a Press the
$
or
%
button.
b Press the
v
button.
Result: The minutes flash.
c Press the
$
or
%
button.
d Press the
v
button.
Result: OFF is displayed for a few
seconds, you can now set the
timer switch-off time.
5. Set the timer switch-off time.
a Press the
$
or
%
button.
b Press the
v
button.
Result: The minutes flash.
c Press the
$
or
%
button.
d
Press the
v
button.
Result:
VOL XX is displayed, where XX
corresponds to the volume already
set.
6. Press $ or % button to adjust the volume level
and press the
v
button.
Result: The source to be selected is displayed.
7. Press
the
$ or %
button to select the desired
source to be played when the system switches on.
`
FM (radio) : a Press the
v
button.
b Select a preset station by
press the
$
or
%
button.
`
DVD/CD (compact disc):
Load one audio CD.
`
USB : Connect the USB device.
8. Press the
v
button.
Result: CHKREC (Do you want to record?) is
displayed.
9. Press the
v
button.
Result: REC N is displayed, you can press the
$
or
%
button to select the REC Y or REC N, and
then press
v
button.
1). If you select the REC N, it will cancel tuner
timing recording even if you have already set
the tuner timing recording.
MX-F630DB-F730DB-ENG-0207.indd 20 2013-3-13 16:05:45
To Next Page
Loading...
