The timer enables you to switch the system on or
off at specific times automatically.
• Before setting the timer, confirm that the current
time is correct.
• During each step, you have a few seconds to set
the required options. If you exceed this time, you
must start again.
• If you no longer want the system to be switched on
or off automatically, you must cancel the timer by
pressing the TIMER ON/OFF button.
Example: You want to wake up to music every morning.
1. Switch the system on by pressing the POWER
( )
button.
2. Press the TIMER SET button until TIME is displayed.
3. Press the ENTER ( ) button.
Result: ON is displayed for a few seconds. You can
set the timer switch-on time.
4. Set the timer switch-on time.
a Press the TUNING/ALBUM , or . button to
set the hours.
b Press the ENTER
( ) button.
Result: The minutes flash.
c Press the TUNING/ALBUM , or . button to
set the minutes.
d Press the ENTER
( ) button.
Result: OFF is displayed for a few seconds. You can
now set the timer switch-off time.
5. Set the timer switch-off time.
a Press the TUNING/ALBUM , or . button to
set the hours.
b Press the ENTER
( ) button.
Result: The minutes flash.
c
Press the TUNING/ALBUM , or . button to set
the minutes.
d Press the ENTER
( )
button.
Result: VOL XX is displayed, where XX corre-
sponds to the volume already set.
6. Press th
e TUNING/ALBUM , or . button to adjust
the volume level, and then press the ENTER
( )
button.
Result: The source to be selected is displayed.
7. Press th
e TUNING/ALBUM , or . button to select
the desired source to be played when the system
switches on.
If you select...
You must also
...
FM (radio)
a
Press the ENTER ( ) button.
b Select a preset station by pressing
the TUNING/ALBUM , or .
button.
MP3/CD
(compact disc)
Load one compact disc.
USB Connect the USB device.
8. Press
the ENTER
( )
button.
Result:
CHKREC (Do you want to record?) is displayed.
Timer Function
Setting the Clock
During each step, you have a few seconds to set the
required options. If you exceed this time, you must
start again.
1. Switch the system on by pressing the POWER
( ) button.
2. Press the TIMER SET button and then press the
ENTER
( )
button, "CLOCK" is displayed.
3. Press the ENTER
( )
button.
The hour flashes.
• To increase the hours, press:
,
• To decrease the hours, press:
.
4. When the correct hour is displayed, press the
ENTER
( )
button. The minutes flash.
• To increase the minutes, press:
,
• To decrease the minutes, press:
.
5. When the correct minute is displayed, press the
ENTER ( )
button. " TIME" appears in the
display.
•
The current time is now set.
•
You can display the time, even when you are
using another function, by pressing the TIMER
SET button once.
•
You can also use the
]
or
[
on the front
panel instead of the TUNING/ALBUM , or .
button in Steps 3 and 4.
To Next Page
Loading...
