Samsung MX-HS6800 - Selecting a Stored Station; Timer Function; Setting the Clock; Setting the Timer

03 Functions
3. Select a station by:
• Pressing and holding the TUNING/ALBUM
,
or
.
button on the remote control to
automatically search for active broadcasting
stations.
4. Press the MO/ST button to switch between
stereo and mono.
• In a poor reception area, select MONO for
a clear, interference-free broadcast.
• This applies only when listening to an FM
station.
5. If you do not want to store the radio station
found, go back to Step 3 and search for
another station.
Otherwise:
a. Press the
¬
button.
b. Or, press the TUNING/ALBUM button
on the remote control to select a program
number in the PRESET mode.
c. Press the
¬
button to save the preset.
6. To store any other radio frequencies required,
repeat Steps 3 to 5.
| NOTES |
✎
In Tuner mode
- In the Manual mode, you can use the
1
or
2
button or the DJ JOG control.
- In the Preset mode, you can use the
1
or
2
button or the DJ JOG control on the
product to search for a stored radio station.
Selecting a Stored Station
To listen to a stored station, follow these steps:
1. Select FM by pressing the TUNER/AUX
button on the product or remote control.
2. Press the TUNING MODE button on the
remote control until “PRESET” is displayed.
3. Press
1
,
2
button on the main unit or
TUNING/ALBUM
,
,
.
on the remote
control to select a preset number.
or
Turn the DJ JOG control left or right on the
main unit to select the stored station.
Timer Function
Setting the Clock
For each step, you have a few seconds to set the
required options. If you exceed this time, you must
start again.
1. Press the TIMER SET button on the remote
control twice. "CLOCK " is displayed.
2. Press the
¬
button on the remote control.
The hour flashes.
• To increase the hours: TUNING/ALBUM
,
• To decrease the hours: TUNING/ALBUM
.
3. When the correct hour is displayed, press the
¬
button, and then the minutes flash.
• To increase the minutes: TUNING/ALBUM
,
• To decrease the minutes: TUNING/ALBUM
.
4. When the correct minute is displayed, press
the
¬
button, and then " TIME" appears in
the display.
Setting the Timer
The timer enables you to set the product to switch
on or off at specific times automatically.
• Before setting the timer, check that the current
time is correct.
• For each step, you have a few seconds to set
the required options. If you exceed this time,
you must start again.
• If you no longer want the product to be switched
on or off automatically, you must cancel the
timer by pressing the TIMER ON/OFF button.
Example: You want to wake up to
music every morning.
1. Press the TIMER SET button until TIME is
displayed.
2. Press the
¬
button.
Result: ON is displayed for a few seconds.
You can set the timer switch-on time.
23 English
MX-HS6800-ZN-ENG-20140429.indd 23 2014/8/13 14:19:31