To Next PageTo Next PageWhy is my Samsung Ranges oven not clean after self-cleaning?
If your Samsung Ranges oven is not clean after self-cleaning, it could be because the oven controls were not set correctly, so see the section on self-cleaning. Also, if the oven was heavily soiled, wipe up heavy spillovers before starting the self-cleaning cycle. Heavily soiled ovens may need to self-clean again or for a longer period of time.
What to do if my Samsung Ranges oven door will not open after a self-cleaning cycle?
If the oven door of your Samsung Ranges will not open after a self-cleaning cycle, it is likely because the oven is still too hot. Allow the oven to cool down.
Why do my Samsung NE595R0ABWW Ranges surface units not maintain a rolling boil or cook fast enough?
If your Samsung Ranges surface units don't maintain a rolling boil or cook fast enough, it might be due to improper cookware. Use pans which are flat and match the diameter of the surface unit selected. In some areas, the power (voltage) may be low, so cover the pan with a lid until the desired heat is obtained.
Why does food not bake or roast properly in my Samsung NE595R0ABWW oven?
If food does not bake or roast properly in your Samsung Ranges oven, it could be due to the oven controls not being set correctly. See the chapter on operating the oven. Also, check if the oven rack has been positioned incorrectly, refer to the section on using the oven racks. Finally, ensure you are using the correct cookware or cookware of the proper size.
How to level a Samsung NE595R0ABWW?
To level your Samsung Ranges, place the oven rack in the center of the oven and put a level on the oven rack. Adjust the leveling legs at the base of the range until the oven rack is level. If the floor is sagging or sloping, contact a carpenter to correct the situation. Also, ensure the kitchen cabinets are square and provide sufficient room for installation. If the kitchen cabinets are not square and built too tightly, contact a builder or installer to make the appliance accessible. If carpet is interfering with movement of the range, provide sufficient space so the range can be lifted over the carpet.
What to do if my Samsung Ranges oven control beeps and displays an F error code?
If your Samsung Ranges oven control beeps and displays an F error code, it indicates a function error. First, press the CLEAR/OFF pad and restart the oven. If the problem continues, disconnect all power to the range for at least 30 seconds and then reconnect the power. If this does not solve the problem, call for service because it could be due to: a shorted key (-SE-), oven sensor issues (E-27, E-28), oven heating errors (E-08, E-0A) or door locking error (E-0E).
What to do if my Samsung Ranges display shows error C-20?
If your Samsung Ranges display shows a C-20 error, it could be due to the oven sensor being open or shorted. If the oven sensor is open: 1. Disconnect the power. Open the back cover and disconnect the sensor harness from the control. 2. Measure the sensor resistance. If there are any issues, replace the oven sensor. 3. If the oven sensor is fine, inspect the harness for damaged terminals or wires. 4. Check the resistance of the oven sensor connector on the main PCB.
What to do if my Samsung NE595R0ABWW Ranges oven will not turn on?
If your Samsung Ranges oven won't turn on, there are a few potential causes: * Ensure the range is completely plugged into a live, properly grounded electrical outlet. * Check for a blown fuse or tripped circuit breaker in your home and replace the fuse or reset the circuit breaker if necessary. * Make sure the oven controls have been set properly. See the chapter on operating the oven. * If the oven is too hot, allow it to cool down.
General| Type | Freestanding Electric Range |
|---|---|
| Oven Capacity | 5.9 cu. ft. |
| Cooktop Surface | Ceramic Glass |
| Number of Burners | 5 |
| Color | Black |
| Width | 29.875 inches |
