Upgrading Memory
A memory is installed in the memory slot at the bottom of this computer. The procedures
to replace the memory are described below.
Before You Start!
Replace new memory only after shutting the computer down completely. Do not
replace memory when the computer is in Sleep mode.
Disconnect main power plug and remove the battery before continuing.
Only use the same type of memory as specied in the Product Specication.
The memory compartment cover may differ from the gure below.
You must use only memory modules
with the specications (DDR2 or
DDR3) printed on the memory slot that
appears when you open the memory
compartment cover at the bottom.
e.g) in the case of using DDR2
Replacing the Memory
1
Remove the screw on the memory
compartment cover at the bottom of
the computer using a screw driver.
Fixing Screw
2
Pull the memory module latches
outward. The memory module will pop
up.
Remove the memory module out at an
angle of 30 degrees.
To Next Page
Loading...
