Samsung NP-P580 - Setting a Boot Password

106
Setting a Supervisor Password
A Supervisor Password is required to turn the computer
on or to start the System Setup.
When setting a Supervisor Password, users other than a
supervisor cannot use the computer.
1
Select the Security menu in the BIOS Setup.
2
In the Set Supervisor Password item, press
<Enter>.
3
Enter a password, press <Enter>, re-enter the
password for conrmation, and press <Enter> again.
The password can be up to 8 alphanumeric
characters. Special characters are not allowed.
4
The supervisor password has been set.
The supervisor password is required to turn the
computer on or to enter the BIOS Setup.
For some models, if the password entered message
appears in the Setup Notice window, the settings are
not complete until the Enter key is pressed.
Setting a Boot Password
When setting a password, you have to enter a password to use the computer or enter the BIOS Setup.
By conguring a password, you can restrict system access to authorized users only and protect data and les saved
on the computer.
Before You Start!
 Do not lose or forget your password.
 If you have forgotten your password, contact a Samsung service center. In this case, a service fee will be charged.
XXXXXXXX