91
Troubleshooting for Anynet+
Problem Possible Solution
Anynet+ does not work. Check if the device is an Anynet+ device. The Anynet+ system supports Anynet+ devices only.
Check if the Anynet+ device power cord is properly connected.
Check whether Anynet+ (HDMI-CEC) is set to On in the System menu.
product off and on again.
Check if the Anynet+ function of the Anynet device is set on.
I want to start Anynet+.
Check if the Anynet+ device is properly connected to the product and check if the Anynet+ (HDMI-CEC) is set to On
in the System menu.
I want to exit Anynet+.
Press the SOURCE
Disconnecting
Anynet+ device ...
on the screen.
You cannot use the remote control when you are configuring Anynet+ or switching to a view mode.
Use the remote control after the product has completed Anynet+ configuration or has finished switching to
Anynet+.
The Anynet+ device does not
play.
You cannot use the play function when initial setup is in progress.
The connected device is not
displayed.
Check whether or not the device supports Anynet+ functions.
Check whether Anynet+ (HDMI-CEC) is set to On in the System menu.
Search Anynet+ devices again.
please repeat the device scan.
To Next Page
Loading...
