27
Cautions when connecting cables
• Remove the appropriate silicon bar before connecting cables.
– 7 Ø hole: For inserting 7-7.5 Ø cables
– 5.5 Ø hole: For inserting 5.5-6 Ø cables
– 3 Ø hole: For inserting 3-3.5 Ø cables
"
Do not remove silicon bars where there is no cable connection. This will lessen the
protection of your product against water and may result in a malfunction due to water
damage, which will not be covered by the warranty.
Silicone-Bar
• After complete cabling, ensure that there is no gap between the set panel and the silicon
covers.
"
A gap may allow water damage and product malfunction.
Silicon cover
Set panel
• After all the cables are connected, make sure to close the cover and fasten the screws to
ensure it is watertight.
"
Only remove the cover under the following conditions.
Environment: Temperature (below 25 ℃), humidity (below 50 %)
Duration: Less than 2 hours (maximum allowed duration without cover)
To Next Page
Loading...
