6. Test Mode
• Driving Compartment Test
Pre-wash VALVE ON(0.3sec) ➔ OFF(0.3sec) ➔ COLD VALVE ON(0.3sec) ➔ [OFF(0.3sec) ➔
HOT VALVE ON (0.3sec) : OPTION ] ➔ OFF(0.3sec) ➔Rinse VALVE ON(0.3sec) ➔ OFF(0.3sec) ➔
Pump MOTOR ON(0.3sec) ➔ OFF(0.3sec) ➔ MOTOR Left (0.5sec) ➔ OFF(0.5 sec) ➔
MOTOR Right (0.5sec) ➔ OFF(0.3sec) ➔ HEATER RELAY ON(0.3sec) ➔ OFF(0.3sec) ➔ DOOR OPEN
(Function continues when door is closed)
2. THERMISTOR TEST MODE
A. Hold down “1” and “2” keys simultaneously and then press POWER S/W “4” on.
(Whole lamps turn on and display show “tl” after 3 Seconds.)
B. Press the “1” key and display shows “t2”
C. Press the “3” key and display shows the inside temperature of tub.
9SAMSUNG ELECTRONICS CO., LTD
1. Driving Compartment Test Mode
A. Hold down “1” and “2” keys simultaneously and then press POWER S/W “4” on.
(Whole lamps turn on and display show “tl” after 3 Seconds.)
B. The driving compartment can be tested when you press “3” key right after entering
into the initial stage of the TEST MODE.
To Next Page
Loading...
