EasyManua.ls Logo

Samsung PC1MWFMAN - Air Filter Removal; Wiring and Connection; Final Panel Installation Check; Installation Precautions and Notes

Samsung PC1MWFMAN
6 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3
English
3 Press the handle of the air filter and pull it out.
The handle appearance of the air filter may differ,
depending on the model. Refer to the image.
A Type B Type C Type
4 Perform wiring between the indoor unit and the panel:
Unfasten the 3 screws from the electrical part, and then
remove the electrical part.
Connect the connectors on the panel to the connectors on the
indoor unit PCB:
Connect the connectors of the swing motor, remote control
sensor, and humidity sensor on the panel to their respective
connectors on the indoor unit PCB.
Make sure that the colours of the connectors match each other.
Reassemble the electrical part.
Close the air filter.
Humidity sensor
NOTE
If any connector is not connected or is connected to a
different colour connector, both the air conditioner and
the remote control will not operate.
5 Check whether the panel is firmly fixed to the indoor
unit.
Make sure that the screws are fastened tightly until
there is no gap between the ceiling and the panel, and
that the panel is installed in parallel with the ceiling
and the ceiling joints:
If there is a gap between the ceiling and the panel,
adjust the height of the indoor unit.
CAUTION
If the panel is installed incorrectly onto the cassette,
air may leak out.
Make sure that there is no gap here.
Make sure that there is no gap here.
Condensation and drops
Air leaks
Dust
accumulates
Air leaks
from ceiling
Incomplete installation (fastening) produces the problems
as shown in the figure. Be sure to check again after the
installation.
When installing the panel, if there are any gaps
between the panel and the indoor unit due
to incomplete installation (fastening), air and
condensation water may leak into the room. Be sure
to remove gaps by using the indoor unit installation
gauges (on the pattern sheet for installation).
For detailed specifications, refer to the installation
manual for the product.
DB68-07556A-03_SYS WindFree 1way Panel_EU_EN_.indd 3DB68-07556A-03_SYS WindFree 1way Panel_EU_EN_.indd 3 2022-11-25 오전 10:52:362022-11-25 오전 10:52:36

Related product manuals