01 Getting Started
7
English
Connecting to an Antenna
When the TV is initially powered on, basic settings proceed automatically.
✎
Connecting the power cord and antenna.
✎
The PDP device may interfere with an amateur radio or AM radio.
✎
When using two-way radio mobile and portable units or amateur radio or AM radio near by your TV, this may cause the
TV to malfunction.
✎
The position of power input port may differ depending on the model.
Setup (Initial Setup)
When the TV is initially powered on, a sequence of on-screen prompts will assist in configuring basic settings. Press the POWER
P
button.
Setup is available only when the Source is set to TV.
✎
To start the Setup, enter the password using the remote control. The default password is 0-0-0-0.
✎
To return to the previous step, press the Previous button.
1. Menu Language: Selecting a menu language
Press the ▲ or ▼ button, then press the ENTER
E
button. Select the desired OSD (On Screen Display) language.
2. Use Mode: Selecting the usage mode
Press the ▲ or ▼ button, then press the ENTER
E
button.
• Select the Home Use mode. Store Demo Mode is for retail environments.
• When pressing TV controller, the function menu screen appears. Select the MENU(
m
) and press it more than 5 seconds
using the controller. The Store Demo mode is set. Cancel the Store Demo by selecting Source(s) and pressing it
more than 5 seconds.
• Store Demo is only for shop display. If you select it, several functions are not able to use. Please select Home Use when
you watch at home.
ANT OUT
VHF/UHF Antenna
Power Input
or
Cable
Antenna Cable (Not Supplied)
[PE400-ZD]BN68-04363B.indb 7 2012-03-27 �� 4:18:18
To Next Page
Loading...
