01 Getting Started
English
Install the Stand
See separate guide for installing the stand.
Stand (1EA) Guide Stand (1EA) Screws (10EA)
Follow the steps below to connect the TV to the stand.
s
s
s
s
1. Connect the Guide Stand to the Stand
using six screws (M4 X L16) as shown.
2. With your TV upright, connect
the TV to the Stand as shown.
3. Fasten two screws (M4 X L16)
at position , and then fasten
two screws (M4 X L16) at
position .
✎
NOTE
x
Make sure to distinguish between the front and back of the Stand and Guide Stand when assembling them.
x
Make sure that at least two persons lift and move the PDP TV.
x
Stand the product up and fasten the screws. If you fasten the screws with the PDP TV placed down, it may lean to
one side.
Top view
Rear
Guide Stand
Screws (M4 X L16)
Stand
(M4 X L16)
1
2
Screws (M4 X L16)
To Next Page
Loading...
