4-21
→
This message may appear when the connected USB memory or CD media does not include
b
ootable data
.
→
The
"
Reboot and Select the proper Boot device or Insert
a
bootable media in the selected Boot
device and press
a
key" message appears.
→
Check if the signal and power cables are properly connected to the hard disk drive.
→
Check if the hard disk drive is recognized in the BIOS SETUP
.
→
The operating system on the hard disk drive is corrupted. Reinstall Windows
.
19.
The
"
To enter BIOS SETUP, press
<
F2>. To continue, press
<
F1>." message appears.
→
This may happen when the BIOS settings are different from the system environment. In this
case, setup the BIOS according to your system environment
.
→
Press
<
F2>toentertheBIOSSETUP
.
→
Check if the date and time are correct in the BIOS SETUP.
→
Save the settings and restart the system
.
20.
The
'
CMOS Checksum error
’
message appears.
→
This message may appear when the CMOS battery of the main board is completely discharged
.
In this case, replace the battery with
a
new one of the same type and set up the BIOS SETUP
according to your system environment.
21.
Windows boots up in safe mode
.
→
This may happen when Windows was not shut down normally. Therefore, shut down the system
by selecting Start
>
Turn Off Computer
.
→
This may happen when the system settings have been incompletely recognized
.
→
Run Check Disk
.
22. I
cannot boot up the computer with
a
USB floppy drive or from USB memory
.
→
Check if the diskette is bootable
.
→
This may happen when the booting priority of the device is low. In this case, change the
booting priority in the BIOS SETUP
.
◆
When shutting down the computer
23.
The computer is not shut down
→
If Windows does not end normally, you can forcibly shut down the system by pressing the
Power button
.
If the power-saving feature is activated on the
P
ower button
,
press the Power
button for more than
4
seconds to turn the computer off
.
If the computer is then turned on again,
Check Disk is automatically run
.
-
This Document can not be used without Samsung's authorization
-
4.
Troubleshooting
To Next Page
