Control Lever
FLOORING
For proper installation, you must place this
refrigerator on a level, hard surface that is the
same height as the rest of the fl oor. This surface
should be strong enough to support a fully loaded
refrigerator. To protect the fi nish of the fl ooring, cut
a large section of the cardboard carton and place
it under the refrigerator where you are working.
When moving a refrigerator, you need to pull and
push it straight forwards or back. Do not wiggle it
from side to side.
ACCESSORIES AND
REQUIRED TOOLS
The following accessories are included with your
refrigerator:
Hex wrench Fastener
Required Tools (Not provided)
You need the following tools to complete the
installation of your refrigerator:
Philips
screwdriver(+)
Flat-blade
screwdriver(-)
Socket wrench
(13/32”) (10mm)
Pliers
Allen wrench
(3/16”) (5mm)
REMOVING THE
REFRIGERATOR DOORS
For some installations, you need to remove the
fridge doors and freezer drawer so you can
move the refrigerator to its fi nal location. Do not
remove the doors/drawers if you don’t need
to. If you do not need to remove the refrigerator
doors or drawers, go to ‘Adjusting the Level’
on page 14. If you need to remove the doors
and drawers. continue below. Before removing
the doors or drawers, make sure you read the
following warnings:
WARNING
Disconnect power to the refrigerator before
removing the door or drawer.
• Be careful not to drop, damage,
or scratch the doors/drawer while
removing them.
DA68-02952A-01.indb 10DA68-02952A-01.indb 10 2013. 12. 3. 8:502013. 12. 3. 8:50
To Next Page
Loading...
