USING THE TWO LEVER DISPENSER
Press the ice type or water button to select the type of you want
\
Cubed I Crushed
Using the ice Dispenser ( 1 )
Place a glass underneath the two lever dispenser and push gently against the
dispenser upper lever with your glass.
Make sure the glass is in line with the dispenser to prevent the ice from bouncing
out.
Using the Water Dispenser ( 2 )
Place a glass underneath the two lever dispenser and push gently against the
dispenser lower lever with your glass.
Make sure the glass is inline with the dispenser to prevent the water from bouncing
out.
CAUTION
Before or during using, wash ice bin/bucket with a mild
detergent, rinse well, and dry thoroughly it. Do not use
harsh or abrasive cleaners or solvents.
When Cubed Ice is selected after using the Crushed Ice
mode, a small amount of residual crushed ice might be
produced.
In case ice doesn't come out, pull out the ice bucket and
press the test button located on the right side of ice maker.
Do not press the test button continuously when the tray is
filled with ice or water. Water may overflow or ice jamming
may occur
Normal Use
To fill the ice bucket to maximum capacity after installation,
make sure to do the following steps.
1.
2.
3.
4.
Test button
Allow your refrigerator to operate and cool down for 24 hours (or 1 full day).
Waiting 24 hours will allow your ice maker to cool properly.
Dispense 4 to 6 ice cubes into the glass.
After 8 and 16 hours, dispense a full glass of ice.
the
o When you need to press the Test button, you will hear buzzer sound (ding-dong). Then you have to
stop pressing it.
,, Check the buzzer sound (ding-dong) again after 4-5 minutes.
To Next Page
Loading...
