Samsung RS2530B - Page 89

No Error Items LED TROUBLE
15
EXT-SENSOR
Ambient Temp. Sensor Error- This can be an Electric wire cut, short-
circuit, contact failure, or missing sensor. This can also be caused by a
temperature reading > 122° or < -58 ° F.
16
F-SENSOR
Freezer Compartment Sensor Error- This can be an wire cut, short-
circuit, contact failure, or missing sensor. This can also be caused by a
temperature reading > 122° or < -58 ° F.
17
F-DEF-SENSOR
Freezer Room Defrost Sensor Error- This can be a wire cut, short-circuit,
contact failure, or missing sensor. This can also be caused by a
temperature reading > 122° or < -58 ° F.
18
F-FAN ERROR
This error indicates the Freezer Evap. Fan is not spinning at the correct
RPM or the fan feedback line is open.
Samsung 'Refrigerator' Diagnostic Code Quick Guide
19
C-FAN ERROR
This error indicates the Condenser Fan is not spinning at the correct RPM
or the fan feedback line is open.
20
CF-SENSOR 4-Door
CF Room Sensor Error- This can be a wire cut, short-circuit, contact
failure, or missing sensor housing. This can also be caused by a
temperature reading > 122° or < -58 ° F.
20
FRENCH DOOR ICE
ROOM SENSOR
Ice Room Compartment Sensor Error- This can be an Electric wire cut,
short-circuit, contact failure, or missing sensor housing. Cause is also a
temperature reading > 122°or < -58 ° F.
21
F-DEFROSTING
ERROR
Freezer Compartment defrosting heater- wire cut, short-circuit, contact
failure, missing sensor housing, or defective temperature fuse/bi-metal.
Defrost on for over 80 minutes
22
CF-FAN ERROR
4-Door
This error indicates the CF Compartment Evap. Fan is not spinning at the
correct RPM or the fan feedback line is open.
23
CR-FAN ERROR
4-Door
This error indicates the CR Compartment Evap. Fan is not spinning at the
correct RPM or the fan feedback line is open.
23
FRENCH DOOR ICE
ROOM FAN ERROR
This error indicates the Ice Room Compartment Evap. Fan is not spinning
at the correct RPM or the fan feedback line is open.
25
ICE PIPE HEATER
ERROR
Error is displayedwhen the ice maker fill pipe heater is open or shorted.
26
Uart ERROR
COMMUNICATION
This error is not applicable, if the error is detected during diagnostic
testing please ignore it.
27
L↔M ERROR
COMMUNICATION
Communication error within the Main PCB
28
P↔M ERROR
COMMUNICATION
Communication between the Main PCB and Keypad